Instructions for drilling your helmet
If you have purchased our horns and wish to install them on your own helmet these instructions should help.
Place a piece of tape over the end of the horns and punch out the holes through the tape. This will give you the exact distance between the holes.
Place the tape on your helmet where you want to install the horn and start to drill leaving only a slight hole in each location. Do not drill through the tape as it might distort the tape making it necessary to prepare another tape template. Remove the tape and continue drilling your holes. Do the same thing on the other side of the helmet. When drilling your holes please make sure that there is no padding or fabric directly behind the areas where you will be drilling. If there is fabric cut a hole allowing the drill bit to go through. If you do not do this you may damage the interior of your helmet.
Best of Luck
Shiela
